Car Gear Picks

Photos from current listings. Actual item, color, and included accessories may vary.

Nissan Control Arm Buying Guide

Nissan control arms connect the chassis to the wheel hub and are sold either as bare arms or pre-assembled with ball joints and bushings. The core trade-off is stamped steel with press-fit rubber bushings versus cast or forged aluminum with serviceable joints; OEM-grade castings and sealed joints are the durable tier, while thin stamped arms with unbranded ball joints are the compromise. Match the arm to the exact chassis code and engine, and replace both sides at the same mileage.

Arm Material:Cast aluminum / stamped steel / forgedJoint Type:Sealed ball joint vs serviceableKit Contents:Bare arm / arm + ball joint / full kitFitment Basis:Chassis code & engine
Typical price range$101.99 – $247.99

At a glance

Category
Suspension, Steering & Brake Parts
Data updated
Nov 15, 2026

Current offers

Highlights

  • OEM front lower arms are typically cast aluminum or stamped steel; cast arms resist fatigue better under pothole loads but cost more.
  • Pre-assembled arms with ball joints cut labor: the ball joint and bushing are already pressed in and torqued to spec.
  • Ball joint stud diameter and taper must match the knuckle; a mismatched taper can loosen and damage the spindle.
  • Aluminum arms weigh roughly 30-40% less than steel and reduce unsprung mass, but steel arms tolerate road salt and gravel strikes better.

Best use cases

  • Daily-driven Rogue or Altima: buy a pair of pre-assembled front lower arms with sealed ball joints; skip bare arms unless you have a press.
  • 350Z or sporty Nissan: choose forged or cast aluminum arms with serviceable ball joints for track or spirited driving; skip stamped steel economy arms.
  • Maxima or older high-mileage sedan: replace the full 4-piece front kit including stabilizer links when bushings are cracked; skip single-arm swaps that leave worn opposite-side parts.

Buying tips

  • Confirm the chassis code (e.g., Rogue S35 vs T32, Altima L33, 350Z Z33) and engine; arm geometry differs between generations and powertrains.
  • Choose cast aluminum or forged steel for performance or rust-belt use; stamped steel is acceptable for light-duty daily driving.
  • Pre-assembled arms include ball joints and bushings; bare arms require a hydraulic press and alignment afterward.
  • Replace arms in pairs and budget a professional four-wheel alignment immediately after installation.

Specs

Arm MaterialCast aluminum / stamped steel / forged
Joint TypeSealed ball joint vs serviceable
Kit ContentsBare arm / arm + ball joint / full kit
Fitment BasisChassis code & engine

Related searches

What to check before buying

  • Verify the model year and chassis code against the listing fitment table, not just the model name.
  • Confirm ball joint stud diameter and taper match your knuckle; measure the old stud before ordering.
  • Check whether the arm includes the ball joint, bushing, and hardware; bare arms need separate joints and bolts.
  • Inspect subframe mounting points for rust or elongation before installing new arms.

FAQ

All Suspension, Steering & Brake Parts buying guides

Data sources: eBay / Amazon listings and product attribute feeds Data updated Nov 15, 2026.

Some links on this page are affiliate links. If you buy after clicking one, we may earn a commission at no extra cost to you. This does not change which products appear here or their order. Affiliate disclosure.